Bug 2535305 (CVE-2026-89946)

Summary: CVE-2026-89946 kernel: ASoC: cs35l33: drain threaded IRQ before runtime suspend
Product: [Other] Security Response Reporter: OSIDB Bzimport <bzimport>
Component: vulnerabilityAssignee: Product Security <prodsec-ir-bot>
Status: NEW --- QA Contact:
Severity: medium Docs Contact:
Priority: medium    
Version: unspecifiedCC: akhatavk, aos-team-art-private, asdas, dpaolell, jdelft, jupierce, lgarciaa, mbiarnes, ppalepu, ppostler, prdhamdh, rhel-process-autobot, sghai, sidsharm, suppawar, vlaad, watson-tool-maintainers
Target Milestone: ---Keywords: Security
Target Release: ---   
Hardware: All   
OS: Linux   
Whiteboard:
Fixed In Version: Doc Type: ---
Doc Text:
A flaw was found in the Linux kernel's Audio System on Chip (ASoC) cs35l33 driver. This vulnerability occurs because the driver does not properly stop an active interrupt request (IRQ) thread before the audio codec enters a low-power suspend state. This oversight allows the IRQ thread to continue operating when it should not, potentially leading to incorrect hardware resource management. The consequence of this flaw could be system instability or a denial of service, where the system becomes unresponsive or crashes.
Story Points: ---
Clone Of: Environment:
Last Closed: Type: ---
Regression: --- Mount Type: ---
Documentation: --- CRM:
Verified Versions: Category: ---
oVirt Team: --- RHEL 7.3 requirements from Atomic Host:
Cloudforms Team: --- Target Upstream Version:
Embargoed:

Description OSIDB Bzimport 2026-09-16 12:00:14 UTC
In the Linux kernel, the following vulnerability has been resolved:

ASoC: cs35l33: drain threaded IRQ before runtime suspend

cs35l33_runtime_suspend() currently switches the codec into
regcache_cache_only(true) and powers it down without first quiescing the
threaded IRQ registered by devm_request_threaded_irq(). That leaves a
window where cs35l33_irq_thread() can still run after suspend has closed
off live register access.

A running system can reach this during runtime PM while the driver still
has critical fault IRQs unmasked. If the threaded handler runs in that
window, it reads volatile INT_STATUS_1/2 after cache_only has been
enabled, ignores the regmap_read() failures, and can still drive the
AMP_SHORT_RLS, CAL_ERR_RLS, OTE_RLS, and OTW_RLS release paths.

Use disable_irq() before entering cache_only/power-off so any in-flight
threaded handler is drained and no new IRQ thread can run during the
suspended state. Re-enable the IRQ only after runtime_resume() has
restored live register access with regcache_sync(). Since probe only
warns if devm_request_threaded_irq() fails, track whether the IRQ was
actually installed before disabling or re-enabling it.