|Summary:||In second stage Upgrade Adaptec 152x Scanning SCSI Bus Fails|
|Product:||[Retired] Red Hat Linux||Reporter:||mb12t|
|Component:||bootpc||Assignee:||David Lawrence <dkl>|
|Status:||CLOSED NOTABUG||QA Contact:|
|Fixed In Version:||Doc Type:||Bug Fix|
|Doc Text:||Story Points:||---|
|Last Closed:||1998-12-29 20:24:44 UTC||Type:||---|
|oVirt Team:||---||RHEL 7.3 requirements from Atomic Host:|
|Cloudforms Team:||---||Target Upstream Version:|
Description mb12t 1998-12-03 20:59:03 UTC
Probe did not find the Adaptec 6360, neither did Scan of the SCSI bus following specific settings of aha152x=0x340,11,1. The Error "I can't find the device anywhere on your system" appeared. Those parameters are correct. The Hardware is a ZEOS Pantera rattler Mother board number 010-0043-04. I'm running PhoenixBIOS number 453-0027-05. The processor is a 486/DX2. The Adaptec driver is AIC-6360 version 1.20L. Technical support for this board is now with www.micronpc.com 1-800-228-5390 and 1-800-554-5220.
Comment 1 Jay Turner 1998-12-09 18:33:59 UTC
Please verify the address and irq jumpers, as your report exhibits the symptoms of a mis jumpered adapter.
Comment 2 Mike Wangsmo 1998-12-16 21:05:59 UTC
Doug, any ideas?
Comment 3 Doug Ledford 1998-12-16 21:44:59 UTC
The "I can't find ... " error messages will happen when any of several conditions occur. It could be that the card itself isn't responding to address 0x340, that the card did respond to address 0x340 but either irq 11 or dma 1 are already in use by something else that can't share the irq or dma address with the scsi card, or it could be that the card is there, but responding with a different ID to the probe than the 152x driver is looking for. The thrid option isn't very likely since changing the probe values on the 152x class chips is not an easy option last I knew. There could also be a timing issue involved. If the bus speed is turned up real high on the ISA bus (for eg. the 8 bit I/O delay is set to only 1 wait state) then it may be that the linux driver is out-running the card while the dos/windows driver might work due to embedded delays. At this point, there are really too many possibilities to list without further description of exactly what happened when the module was loaded and a full list of all the messages produced by the 152x driver leading up to the device not found message. To get that, you need to hit ALT-F4 after the install program says the device isn't there and record all of the messages about the 152x scsi driver and then update this bug report with that information.
Comment 4 David Lawrence 1998-12-29 20:24:59 UTC
No responce from user. Bug closed. Reopen later if needed.