Description of problem:
The Fedora Core 6 version of first boot enables and runs (what I believe to be)
an x.org implementation of X11 correctly. Upon finishing the first execution of
firstboot, the operating system attempts to implement the next step in the setup
process, however at this point whatever the os does next causes the X11 graphics
to corrupt and system to freeze. Upon restarting of the os, firstboot runs
again, however upon initiallization of the gui for firstboot the system hangs
witht he same graphics corruption as seen previously post-firstboot.
I'm knowlegable that this problem may not be confined to just firstboot.
However, I am unable to determine why firstboot would have no graphical problems
undtill after its first execution
Version-Release number of selected component (if applicable):
Fedora Core 6 (Zod stable) Firstboot v.* (version included in DVD-iso as of
Pentium IV - 2.6C
Corsair 512mb PC3200 Ram
Radeon X800XT PE (I know recent ATI cards have support problems.
2x WD1200JB EIDE Hard-drives
Steps to Reproduce:
1.Install Fedora on hdb1 partition using DVD-iso boot disk (as of 1/24/07)
2.Install grub using hda1 Windows intall as primary boot and hdb1 Fedora as 2nd
3.Remove DVD-iso boot disk
5.Use grub to boot into hdb1 install of Fedora Core 6
6.Wait for initial setup
7.Wait for Firstboot to load
8.Configure Firstboot accordingly
9.Firstboot finishes and GUI begins loading.
10.System Freeze + Display grapics corruption.
11.Restart Machine (Hard restart all controls ineffective)
12.Use grub to boot into hdb1 install of Fedora Core 6
13.Wait for initial setup
14.Upon start of Firstboot, system freezes with display corruption as before.
System freezes.. all controls are ineffective.. Background image for next
expected GUI implementation loads, however graphical corruption can be seen
across the top 10% of the display.
Firstboot runs and is configured appropriately. Firstboot ends. GUI
implementation begins and continues without freezing
It would be nice to know if Firstboot uses a display driver or X11
implementation other than what is used for the main GUI. I could understand if
firstboot ran its own graphics display drivers to ensure maximum compatability
durring a initial install, however I am puzzled how a corruption which occurs
after firstboot can cause problems durring subsequent executions.
If you are booting with rhgb, firstboot takes over the X server that was already
started. If you are not, it starts its own server using a configuration that
was probed for. This config should be very similar to the one that ran in
anaconda as it uses the same code.
Can you please test with Fedora 7 test 1 when released and see if it's working
better for you? I know we did some work with firstboot, rhgb, and so forth
after FC6 to fix some sporadically appearing problems like this.