Description of problem: When fusor-installer (or launch-fusor-installer) fires up, and you've gone through and configured values, you'll end up with something like this: If you DO NOT want to configure networking please set 'Configure networking on this machine' to No before proceeding. Do this by selecting option 'Do not configure networking' from the list below. How would you like to proceed?: 1. Proceed with the values shown 2. Change Network interface eth1 3. Change IP address 192.168.122.10 4. Change Hostname fusor.example.com 5. Change Network mask 255.255.255.0 6. Change Network address 192.168.122.0 7. Change Host Gateway 192.168.155.1 8. Change DHCP range start 192.168.122.11 9. Change DHCP range end 192.168.122.254 10. Change DHCP Gateway 192.168.122.1 11. Change DNS forwarder 192.168.155.1 12. Change Domain example.com 13. Change Foreman URL https://fusor.example.com 14. Change NTP sync host 1.centos.pool.ntp.org 15. Change Timezone US/Eastern 16. Change BMC feature enabled false 17. Change BMC default provider ipmitool 18. Do not configure networking 19. Do not configure firewall 20. Cancel Installation To go through and configure everything, you've been simply doing n+1 each time, entering a value, and moving on. Once you have everything configured though, you're supposed to stop doing that, and use #1. It would be a more natural progression, as well as being a bit more streamlined, in that you won't know if you can proceed with the values, without looking at the values first, yet at the bottom of the values is where we list cancel. We should flip 'Proceed with the values shown' with 'Cancel Installation'. Version-Release number of selected component (if applicable): Tech Preview Additional info: