Good morning, I installed Fedora Linux on a PC with an NVIDIA GeForce RTX 3050 graphics card. I booted from the installation media, launched the installer, and installed Fedora without any issues. After restarting into the new system, the GNOME configuration tool started, and I followed the steps normally until the time zone selection step. I selected my time zone and clicked "Next," but at this point, the GNOME configuration tool became unresponsive while transitioning to the next page. Although I could still use the rest of GNOME Shell (especially the Control Center), I was unable to create a user account. Additionally, I couldn't switch to a TTY to install the drivers since I didn't have a user account set up. Fortunately, I managed to restart in recovery mode via GRUB, reset the root password to install the proprietary NVIDIA drivers, and return to the GNOME configuration tool. However, not everyone may know how to do this, as I already had experience with TTY. Could you please look into this issue? Thank you. Reproducible: Always Steps to Reproduce: 1. Install Fedora 42 with an NVIDIA RTX 3050 graphics card 2. Boot the newly installed system 3. On gnome-initial-setup tool, go to the time zone selection step 4. Choise the timezone and click on "next" Actual Results: The gnome-initial-setup tool became unresponsive Expected Results: The GNOME configuration tool works on an NVIDIA RTX 3050 Additional Information: ## Hardware Information: - **Hardware Model:** HP Victus by HP 15L Gaming Desktop TG02-2xxx - **Memory:** 16.0 GiB - **Processor:** Intel® Core™ i5-14400F × 16 - **Graphics:** NVIDIA GeForce RTX™ 3050 - **Disk Capacity:** 512GB I have a separate /home partition