Red Hat Bugzilla – Bug 3450
problem with raidtools on RH6.0 system
Last modified: 2008-05-01 11:37:50 EDT
I just installed RH6.0 systeme and i want to set up a
The RAID0 partition is based on two SCSI disk.
They are connected through an Adaptec AIC-7890/1 Ultra2 SCSI
I can set up my partition as it s described in the Software
RAID Howto but when i reboot i got the following messages.
kernel: kmod: failed to exec /sbin/modprobe -s -k
md-personality-2, errno=2 and then i can't mount the
RAID0 partition /dev/md0.
After the boot if i launch
/sbin/modprobe -s -k md-personality-2
It works and i can mount the device.
Do you have the RAID module on the initrd?
Well you got it
I was using the initrd file installed by the initial installation.
I put the raid module on it and it works quite well now.
The fact is that the documentation of raidtools package is quite
Thanks for the tip