I have an IBM ThinkPad i1472 which uses a 0Z6832/6833 Card Bus. The only PCMCIA card that I have is an IBM Credit Card Ethernet Adapter. The "cardctl ident" command shows the correct type of card in the slot. However, when I boot my computer after enabling networking, I get the following error messages: eth0: NE2000 Compatible: port 0x300, irq 11, mem 0xc4036000, 10baseT port, hw_addr 00:04:AC:24:0F:31 Hw. address read/write mismap 2 Hw. address read/write mismap 4 ... eth0: Tx timed out, cable problem? TSR=0x3, ISR=0x0, t671 eth0: pcnet_reset_8390() did not complete