Description of problem: This afternoon I upgraded an F8 system to F9 using the preview DVD; I then installed ca. 200 updates via yum. After the upgrade, my Hauppauge WinTV PVR-150 card no longer works. The card is recognized at boot time (see dmesg output below), but when I try to either view TV using VLC or cat /dev/video1 to file (raw mpeg), the output is nothing but black. The setup worked fine under FC6, FC7, and F8 with the atrpms ivtv-kmod packages. Version-Release number of selected component (if applicable): $ uname -r 2.6.25-1.fc9.i686 Additional info: dmesg output $ dmesg | grep ivtv ivtv: Start initialization, version 1.2.0 ivtv0: Initializing card #0 ivtv0: Autodetected Hauppauge card (cx23416 based) ivtv0: Autodetected Hauppauge WinTV PVR-150 cx25840 1-0044: cx25843-24 found @ 0x88 (ivtv i2c driver #0) tuner 1-0043: chip found @ 0x86 (ivtv i2c driver #0) tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0) wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #0) ivtv0: Registered device video1 for encoder MPG (4096 kB) ivtv0: Registered device video32 for encoder YUV (2048 kB) ivtv0: Registered device vbi0 for encoder VBI (1024 kB) ivtv0: Registered device video24 for encoder PCM (320 kB) ivtv0: Registered device radio0 for encoder radio ivtv0: Initialized card #0: Hauppauge WinTV PVR-150 ivtv: End initialization ivtv0: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes) ivtv0: Encoder revision: 0x02060039
For some reason, after two reboots, it is working now. Marking as resloved. Sorry for the trouble.