Red Hat Bugzilla – Bug 496194
F10: Anaconda errors on Network Manager - never configures eth0
Last modified: 2009-06-08 15:39:52 EDT
Description of problem:
F10 x86_64 installation. Anaconda gets to where it says Network Manager is configuring eth0, then error shows:
There was an error configuring your network interface. Retry.
Version-Release number of selected component (if applicable):
3 times so far.
Steps to Reproduce:
1. see above
NetworkManager never configures interface.
Is this better in rawhide?
I don't normally use rawhide. Can you run an install from rawhide? Can you produce an iso?
There's at least the snapshot release made last week and the impending RC. Those have ISOs. And yes you can usually install from rawhide - at least on the days where there's a tree.
Investigating this problem. It may have been due to declaring static ip and having a list of nameservers. If I just include only one nameserver then the error message does not show.
If I get time I'll try from rawhide.