Description of Problem: Upgraded from RH 7.3 to 8.0. NIC card does not respond but get synch/synch light via mii-tool. At boot NIC loads (but failes, says not present) before network....then appears to load after hardware detection. Controller and NIC card drivers are loaded. Ifconfig status shows that it is running. Fails to make active through GUI. ifup eth0 fails to start. Version-Release number of selected component (if applicable): Version of Nic card: 3Com 3CCFE575CT-D1, P/N 16-0488-001 Rev:B How Reproducible: Always Steps to Reproduce: 1. Every boot/re-boot 2. ifup eth0 3. Actual Results: Expected Results: Additional Information: Please advise.
This NIC card is on a Dell Latitude C600. I am currentley in RH RH133 course. Class instructor has advised me to check here. Thanks again.